Scratch Built - Micro Drone V3

Here is the finished Micro Drone V3.

Maiden with 2.5 inches CG from leading edge. Using 2213N 800kv motor and 3S 1000mAa LiPo. The motor does not have enough speed but enough torque. I am considering to change the motor to 1450kv motor to speed the plane up.

Here are the part list:

• 3 x Servos
• 3S 1000mAa LiPo
• 1450kv outrunner motor
• Motor mount
• 8 x 4 prop
• 25Amp ESC
• 6 ch receiver

4 inches KFm2 chord. You can find more knowledge about KFm wing profile here.

27 x 8 inches wing.

7 x 2.5 inches aileron.

Motor mount.

12.75 x 5 inches stabilizer.

3 inches width fuselage with 6mm side walls.

Aileron servos.

Elevator servo.

Close look at the servo arm.

Bottom opening.

Bottom lid closed using  Velcro Brand Sticky Back Tape.

Added vertical stabilizer.

Complete MicroDrone V3 setup.

Complete MicroDrone V3 setup.